It is currently Wed Sep 08, 2010 3:33 pm

All times are UTC - 6 hours [ DST ]




 Page 1 of 1 [ 1 post ] 

X4 MU3 - Any News?

Author Message
 Post subject: X4 MU3 - Any News?
PostPosted: Thu Feb 04, 2010 9:02 pm 
Site Admin

Joined: Mon Aug 10, 2009 7:58 pm
Posts: 235
Anyone install and using MU3 yet?

I downloaded it Tuesday but haven't had time to install. Things have been pretty busy at work to the point of programming over the weekend even.

What little I have had time to lurk around haven't seen too much that makes a difference with it.

Just wondering if it is a release I should make the time to get it installed. Probably won't have a free couple hours in the next couple weeks.

cncmike



_________________
http://www.cncbasics.com
http://www.cncbasicsforum.com
http://www.mastercamblog.com
http://www.mastercamworld.com
http://www.ultimatemachinist.com

X4 MU3 Mill Level 3
Solids
That's it...:(
Offline
 Profile  
 
Display posts from previous:  Sort by  
 Page 1 of 1 [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
 

Valid CSS!

phpBB skin developed by: phpBB Headquarters
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group